Siemens Sinumerik 840D sl Diagnostic Manual page 189

03/2009
14138 [Channel %1: ] Block %2 Polynomials PO[XH], PO[YH] and PO[ZH] are
not permitted
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Polynomials for the coordinates of a reference point on the tool (PO[XH], PO[YH], PO[ZH]) can only
be programmed, if interpolation type ORICURVE is active. If ORIVECT, ORIPLANE, ORICONxxx is
active, no polynomials can be programmed for coordinates XH, YH and ZH.
Reaction: Correction block is reorganized.
Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Modify the NC program
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14139 [Channel %1: ] Block %2 Polynomial for angle of rotation PO[THT] is not
permitted
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A polynomial for the angle of rotation of orientation (PO[THT]) can only be programmed, if the active
transformation supports it.
Reaction: Correction block is reorganized.
Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Modify the NC program
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14140 [Channel %1: ] Block %2 position programming without transformation
not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Position information was programmed for an axis position but no transformation was active.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify the program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14144 [Channel %1: ] Block %2 PTP movement not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The PTP G code was programmed for a movement other than G0 or G1.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify the program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-189