Siemens Sinumerik 840D sl Diagnostic Manual page 260

Overview of Alarms
NCK alarms
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16710 [Channel %1: ] Block %2 axis %3 master spindle not programmed
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A master spindle function has been programmed (G33, G331, G95, G96) but the speed or the direc-
tion of rotation of the master spindle is missing.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Add S value or direction of rotation for the master spindle in the displayed block.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16715 [Channel %1: ] Block %2 axis %3 spindle not in standstill
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle number
Definitions: In the applied function (G74, reference point approach), the spindle must be stationary.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program M5 or SPOS/SPOSA in front of the defective block in the part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16720 [Channel %1: ] Block %2 axis %3 thread pitch is zero
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: No pitch was programmed in a thread block with G33 (thread with constant pitch) or G331 (rigid tap-
ping).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: The thread pitch must be programmed for the specified geometry axis under the associated interpo-
lation parameters.
X -> I
Y -> J
Z -> K
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16730 [Channel %1: ] Block %2 axis %3 wrong parameter
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
2-260
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009