Siemens Sinumerik 840D sl Diagnostic Manual page 462

Overview of Alarms
NCK alarms
61110 [Channel %1: ] Block %2: Finishing allowance at bottom > depth infeed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The finishing allowance at the base has been specified greater than the maximum depth infeed. Alarm
triggered by following cycles: POCKET3, POCKET4.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Either reduce finishing allowance or increase depth infeed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61111 [Channel %1: ] Block %2: Infeed width > Tool diameter
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed infeed width is greater than the diameter of the active tool. Alarm triggered by fol-
lowing cycles: CYCLE71, POCKET3, POCKET4.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Infeed width must be reduced.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61112 [Channel %1: ] Block %2: Tool radius negative
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The radius of the active tool is negative. This is illegal. Alarm triggered by following cycles: CYCLE72,
CYCLE76, CYCLE77, CYCLE90.
Remedy: Change the tool radius.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61113 [Channel %1: ] Block %2: Parameter for corner radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameter for the corner radius _CRAD has been specified too large. Alarm triggered by following
cycle: POCKET3.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reduce corner radius
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61114 [Channel %1: ] Block %2: Machining direction G41/G42 incorrectly
defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The machining direction of the cutter radius compensation G41/G42 has been incorrectly selected.
Alarm triggered by following cycle: CYCLE72.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Change machining direction.
2-462
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009