Siemens Sinumerik 840D sl Diagnostic Manual page 500

Overview of Alarms
NCK alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61338 [Channel %1: ] Block %2: Positioning speed equal to zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: For some measuring versions, for example measuring spigots, in addition to the actual measuring
paths, intermediate paths are generated that are traversed with a specified feed.
The values for the feed are specified:
- For 840D: in parameters _SPEED[1] and _SPEED[2] in GUD6.
- For 840D sl: in setting data 55631 $SCS_MEA_FEED_PLANE_VALUE and 55632
$SCS_MEA_FEED_FEEDAX_VALUE
61339 [Channel %1: ] Block %2:Correction factor for rapid traverse speed = 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: For 840D: Check parameter _SPEED[0] in GUD6
For 840D sl: Check setting data 55630 $SCS_MEA_FEED_RAPID_IN_PERCENT
61340 [Channel %1: ] Block %2: Incorrect alarm number
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Internal error in measuring cycles.
61341 [Channel %1: ] Block %2: Probe not calibrated in active plane.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE974, CYCLE977, CYCLE978, CYCLE979.
Remedy: Calibrate the probe prior to calling a cycle.
61342 [Channel %1: ] Block %2: Upgrade NCK software version
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Up to measuring cycle software 6.2: _SI[1] in GUD6 has no value or a value < 3
As from measuring cycle software 6.3: Upgrade NCK software version.
61343 [Channel %1: ] Block %2: No tool available for specified tool name
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check tool name.
61344 [Channel %1: ] Block %2: Several tools are active
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Remove tool from another spindle.
61345 [Channel %1: ] Block %2: D number of tool offset, too many digits
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Reduce the D number in _KNUM, check software or MD of flat D number.
2-500
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009