Others - Canon iR5000i Service Manual

CHAPTER 4 IMAGE FORMATION SYSTEM

3.5.4 Others

COPIER>ADJUST>HV-TR>TR-N1
(Use it to adjust the output of the transfer charging current for the first side
of a double-sided print or for a single-sided print of plain paper.)
COPIER>ADJUST>HV-TR>TR-N2
(Use it to adjust the output of the transfer charging current for the second
side of a duplexing print of plain paper.)
Enter the value indicated on the service label if the RAM on the DC con-
troller PCB has been cleared.
COPIER>ADJUST>HV-TR>HVT-TR
(Use it to enter the offset value for the transfer high-voltage output of the
high-voltage unit.)
Enter the value indicated on the label attached to the new high-voltage unit
if the RAM on the DC controller PCB has been cleared or the high-voltage
unit has been replaced.
COPIER>ADJUST>HV-TR>D-HV-TR
(Use it to enter the offset value for the thermistor high-voltage output of the
DC controller PCB.)
Enter the value on the label attached to the DC controller PCB if the RAM
on the DC controller PCB has been cleared or the DC controller PCB has
been replaced.
COPIER>FUNCTION>CLEANING>WIRE-CLN
Execute auto cleaning of the charging wire (five round trips) if the primary
charging wire or the transfer charging wire has been replaced.
COPIER>OPTION>BODY>W-CLN-P
Set the interval at which auto cleaning of the charging wire is executed in
terms of the number of prints.
4-30 P
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001