Connecting Power; Table 2-7 Poe Requirements By Hdz Model - Honeywell HDZ20HD User Manual

32 | HDZ Series IP PTZ User Manual
To power the camera, either PoE or a 24 V AC power connection can be used. If using PoE,
either a switch or PoE injector meeting the PoE+ standard (30 W) or High Power over PoE
(60 W), depending on the model, must be employed (see
page 32
HDZ Camera Model
HDZ20HD(X), HDZ30(X), HDZ30HD
HDZ30HDE, HDZ36E(X)
HDZ20HDE(X)

Connecting Power

CAUTION
connections can be used. If using power over Ethernet (PoE+), please
connect the Ethernet cable to the camera's Ethernet port and plug the
other end of the cable into an IEEE 802.3at-2009 High Power over Ethernet
(PoE Plus) switch. If there is a need to operate the Heater for the Outdoor
model, you will be required to use the 24 V AC cable to plug into the
camera's power connector and power the camera.
IMPORTANT NOTE regarding PoE operation of models HDZ36E(X) and HDZ30HDE
A high power PoE injector capable of supplying at least 60 W is required for proper operation of
outdoor camera model HDZ36E(X) and HDZ30HDE as PoE to IEEE802.3af or IEEE802.3at will
not support these models.
Refer to
power adapter.
www.honeywell.com/security
for more information about powering the HDZ series camera.
Table 2-7 PoE Requirements by HDZ Model
PoE Requirement
PoE+ (30 W)
PoE++ (60 W) supports camera and heater operation for outdoor
installations
PoE+ (30 W) supports camera operation only. If installed outdoors and
heater operation is required, the camera must be powered by 24 V AC.
Note When connecting HDZ20HDE(X) with a PoE power supply, it is recommended to
use either an unshielded network cable or a shielded cable with an unshielded
pigtail connector.
To power up the camera, either PoE+ or 24 V AC power
Figure 2-8 and Table 2-8
Table
when connecting power to your camera through the main
2-7). See Connecting Power on