Configuring Alarms; Alarm Server Settings; Configuring Email Smtp Servers - Honeywell HDZ20HD User Manual

Configuring Alarms

The HDZ Series IP PTZ dome camera supports four alarm inputs and two alarm outputs, as well
as network failure, motion detection, and periodical events. Ensure that the alarm input/output
connections are properly wired before configuring alarm-related settings on the camera (see
Connecting Alarm Inputs/Outputs on page 30
This chapter includes:
•
•
•

Alarm Server Settings

You can set up the camera to send a message to an FTP, email (SMTP), or HTTP server, or to
upload images to an FTP server or email server when an alarm is triggered. FTP, SMTP and
HTTP servers must be configured before alarm messages and/or images can be sent. You can
configure up to two servers of each type.

Configuring Email SMTP Servers

1.
2.
3.
4.
5.
Alarm Server Settings, page 87
Motion Detection Settings, page 95
Periodical Event Settings, page 103

Navigate to System Mail (see
Under SMTP, enter the server name, port, account name, password, and recipient email
address for one or both servers.
Note Contact your network administrator for the needed SMTP values if you do not
have them at hand.
You can select the check box for either the 1st SMTP SSL or 2nd SMTP SSL options to
enable more secure email transmission for the alarm messages.
Enter an email address to be appointed as sender in the Sender email address field.
Click Save to save your mail server settings.
for more information).
• Alarm Input Settings, page 90
• Network Failure Detection
Settings, page 101
Figure 6-1).
6
6
800-11873V4 - A - 07/2014