Upgrading The Software - Honeywell HDZ20HD User Manual

Restoring All Default Settings, Except for the Network Settings
1.
2.
Rebooting the Camera Without Changing the Current Settings
1.
2.

Upgrading the Software

To upgrade the firmware:
1.
2.
3.
4.
5.
6.
7.
8.
9.

Navigate to System Factory Default (see
Click Set Soft Default.
All changes except the network settings are lost and the system restarts after 100
seconds.

Navigate to System Factory Default (see
Click Reboot.
The system restarts without changing the current settings.
Download the software upgrade file to your hard drive. Make a note of the file location.

Navigate to System Software Upgrade (see
Click Browse to locate the upgrade file on your hard drive, and then click Open.
Select the file (uImage+userland.img) to upgrade from the drop-down list.
Note If a switch/main/module upgrade is needed, choose the appropriate upgrade file
from the drop-down list (switch.bin/main.bin/module.bin).
Click Upgrade.
After the upgrade is complete, close your browser.
Open the Start menu, click Control Panel, and then double-click Add or Remove
Programs.
Select Honeywell Viewer from the list of programs and then click Remove.
Open your web browser and access the camera (see
Browser on page 38). Then allow the automatic download of the Honeywell Viewer.
Configuring System Settings | 135
Figure 7-20).
Figure 7-20).
Figure 7-21).
Accessing the Camera from a
800-11873V4 - A - 07/2014