Figure 6-13 Motion Detection: Record Video Clip Options; Figure 6-14 Motion Detection: Upload Image By Ftp/E-Mail Options - Honeywell HDZ20HD User Manual

Figure 6-13 Motion Detection: Record Video Clip Options
2. Select the storage device to record the clip(s) to with the Record to drop-down list.
Options are SD card (default) or NAS. Whichever storage device is selected, that storage
device needs to be configured and connected before video clips can be recorded (see
Storage Settings on page 129
3. In the Pre-trigger buffer field, enter the number of seconds of video to record before the
trigger occurs (from 1 to 9999).
4. To continue to record the video clip for a specified period of time or until the alarm ends,
choose the option that fits your requirements from the following selections:
• Upload for [number] sec and enter a time from 1 to 9999 seconds.
• Upload during trigger active.
Note After making changes to your settings, it is advised to click Save and save your
settings. This can be done at any time, or multiple times during setup.
Sending a Message to the Configured FTP/Email Server
Under Triggered Action, select one or both of the following:
• The Send message by FTP check box to send the message to the FTP server (see
Configuring Email SMTP Servers on page 87
• The Send message by E-Mail check box to send the message to the mail server (see
Configuring Email SMTP Servers on page 87
Uploading Images to a Configured FTP/Email Server
1. Under Triggered Action, select the Upload image by FTP/E-mail check box. The
uploading images options will appear below the check box (see
Figure 6-14 Motion Detection: Upload Image by FTP/E-mail Options
for more information).
for information on setting up an FTP server).
for information on setting up an email server).
Configuring Alarms | 99
Figure 6-14).
800-11873V4 - A - 07/2014