Cisco 800 Series Hardware Installation Manual page 254

Cisco 860, 880, 890 Series
Table 3-4
Power and Link
To wireless LAN
14
PoE
To LAN GE/FE line
(860VAE models
only)
To DSL line
(860VAE models
only)
Cisco Integrated Services Router Hardware Installation Guide
3-46
Verifying the Router Operation (continued)
LEDs to Check
WLAN LINK
WLAN 2.4 GHz
WLAN 5.0 GHz
PoE 0 (880 and
890 series only)
PoE 1 (880 and
890 series only)
PoE 2 (890 series
only)
PoE 3 (890 series
only)
LAN
DSL LINK
DSL ACT
Normal Patterns
Wireless LAN link status:
Green if at least one client is associated.
•
Off if no client is associated.
•
Wireless LAN 2.4-GHz status:
• Green when radio is connected, SSID
signal is being transmitted, and client is associated.
• Slow blinking when radio is connected, SSID is
configured, and signal is being transmitted.
Wireless LAN 5.0-GHz status:
• Green when radio is connected, SSID is configured,
signal is being transmitted, and client is associated.
• Slow blinking when radio is connected, SSID is
configured, and signal is being transmitted.
PoE power status:
• Green when connected and powered.
• Amber when there is a fault with the inline power
supply.
Blinking when there is LAN activity (traffic in either
direction).
Off when the link is down.
On when DSL WAN mode is selected and DSL training
complete.
Blinking when DSL WAN mode is selected but incomplete
DSL LinkUp state such as in-training (slow initially, fast
when almost connected), or controller "OFF", or no cable
attached to DSL connector.
Off when the device is powered off; or GE WAN mode is
selected.
On when the DSL interface is up.
Blinking when there is DSL WAN activity (traffic in either
direction).
Faster blinking when there is heavier traffic.
Off when the device is powered off or the DSL WAN
interface is down.
Chapter 3 Connecting the Router
13
is configured,