Cisco 800 Series Hardware Installation Manual page 183

Chapter 2 Installing the Router
Configuring the Mount
Figure 2-27
2
1
Mount tray
2
DIN Rail Latch Bracket Screws
3 Mount Serial Number
The mount comes configured in a bottom cable exit position, with the rail latches in the slots marked
Bottom. To reconfigure the mount:
Remove the two DIN Rail Latch Bracket Screws (Item 2).
1.
Slide the DIN Rail Latch Brackets (Item 5) and DIN Rail Latch (Item 6) against the spring pressure,
2.
towards the edge of the tray and remove the bracket and latch assembly. Be careful not to lose the
springs.
Remove the DIN Rail Latch Springs (Item 4)
3.
Identify the desired mounting configuration and replace the latch assemblies in slots with the
4.
matching labels, using the reverse order of steps 1 through 3.
Low Profile DIN Mount Configuration
1
3
Cisco Integrated Services Router Hardware Installation Guide
4
5
4
4
DIN Rail Latch Springs
5
DIN Rail Brackets
6 DIN Rail Latch
Installing the Cisco 810 ISR
6
2-31