Preparing To Connect The Router - Cisco 800 Series Hardware Installation Manual

Cisco 860, 880, 890 Series
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
Warning
locations. Statement 1036
Never touch uninsulated telephone wires or terminals unless the telephone line has been
Warning
disconnected at the network interface. Statement 1037
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
Warning
risk of electric shock from lightning. Statement 1038
Warning To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
Warning Before opening the unit, disconnect the telephone-network cables to avoid contact with
telephone-network voltages. Statement 1041
This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
Warning
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call. Statement 1042
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
Warning
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54). Statement 1052
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning

Preparing to Connect the Router

Before you connect the router to the devices, install the router according to the instructions in
the Cisco 860, 880, 890 ISR" section on page
Cisco Integrated Services Router Hardware Installation Guide
3-10
2-38.
Chapter 3 Connecting the Router
"Installing