Cisco 800 Series Hardware Installation Manual page 142

Cisco 860, 880, 890 Series
Table 1-43 LED Descriptions for the Cisco 866VAE, Cisco 867VAE, Cisco 866VAE-K9, and Cisco 867VAE-K9 ISRs
LED Activity
Power/System Power/System LED: Solid
GE_MODE LED: Off
DSL_LINK LED: Off
Power/System LED: Solid
GE_MODE LED: Solid
DSL_LINK LED: Off
Power/System LED: Solid
GE_MODE LED: Off
DSL_LINK LED: Solid or
flashing
1
xDSL ACT Green
xDSL Link Green
GE ACT Green
GE Mode Green
1. xDSL = General term referring to various forms of DSL, includi\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
ng ADSL (asymmetric digital subscriber line) and VDSL (very-high-data-rate digital subscriber line).
Cisco Integrated Services Router Hardware Installation Guide
1-122
Description
Power is on and system running in the ROMMON mode.
Note During the early booting stage, both Power/System, GE_MODE, and
DSL_LINK LED will be turned on temporarily for the power on test.
DSL_LINK and GE_MODE LED will be turned off later after booting
into ROMMON.
Cisco IOS functioning in GE WAN mode.
Cisco IOS functioning in DSL_WAN mode.
Note In Cisco IOS DSL_WAN mode, DSL_LINK LED will be solid after
DSL training complete or flashing during training.
On—DSL interface is up.
Blinking—DSL WAN activity (traffic in either direction).
Faster blinking—Heavier traffic
Off—Device is powered off or the DSL WAN interface is down.
On—DSL WAN Mode is selected and DSL training complete.
Blinking—DSL WAN Mode is selected but incomplete DSL Link Up state,
such as in-training, or controller "OFF," or no cable attached to DSL connector.
Off—Device is powered off or GE WAN mode is selected.
On—GE WAN interface is up.
Blinking—GE WAN activity (traffic in either direction).
Off—Device is powered off or GE WAN interface is down.
On—GE WAN Mode is selected.
Off—Device is powered off or DSL WAN mode is selected.
Chapter 1 Product Overview