Cisco 6260 Installation Manual page 76

Hide thumbs Also See for 6260:
Table of Contents

Advertisement

Safety Requirements
Connect the unit only to DC power source that complies with the Safety Extra-Low Voltage (SELV)
Warning
requirements in IEC 60950 based safety standards.
Do not use this product near water; for example, near a bathtub, washbowl, kitchen sink or laundry
Warning
tub, in a wet basement, or near a swimming pool.
Warning
Never install telephone wiring during an electrical storm.
Warning
Never install telephone jacks in wet locations unless the jack is specifically designed for
wet locations.
Warning
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Warning
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
Warning
risk of electric shock from lightning.
Do not use a telephone to report a gas leak in the vicinity of the leak.
Warning
Warning
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
handles on the port adapters; these types of handles are not designed to support the weight of the unit.
Lift the unit only by grasping the chassis underneath its lower edge.
Warning
This equipment needs to be grounded. Use a green and yellow 14 AWG ground wire to connect the
host to earth ground during normal use.
Warning
This is a Class A product based on the standard of the Voluntary Control Council for Interference by
Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio
disturbance may arise. When such trouble occurs, the user may be required to take corrective
actions.
Cisco 6260 Hardware Installation Guide
2-8
Chapter 2
Preparing for Installation
OL-2365-02

Advertisement

Table of Contents
loading

Table of Contents