Table of Contents
Advertisement
Installing and Replacing Hardware
Do not reach into a vacant slot or chassis while you install or remove a line card or a fan. Exposed
Warning
circuitry could constitute an energy hazard.
Do not stare into the beam or view it directly with optical instruments.
Warning
All cards must be fully seated in the chassis. A push on the faceplate of each card is required for the card
Note
to be fully seated.
6.3.4.1 Installing an OC-3c/OC-3c NI-2 Card
Complete the following steps to install an OC-3c/OC-3c NI-2 card in the chassis. It is important that you
complete each step before moving on to the next step.
Connect a grounding strap to the ESD grounding jack that is located on the top right of the Cisco 6260
Step 1
card cage.
Inspect the NI-2 card. Verify that the daughterboard is fully seated on the main board.
Step 2
Verify that slots 10 and 11 of the chassis have no bent pins.
Step 3
Vertically align the card edge with the card guides at the top and bottom of slot 10 in the chassis.
Step 4
Figure 6-5
Lift up on the ejector levers and gently apply pressure to the bottom of the faceplate while pushing the
Step 5
card into the slot.
Push on the faceplate of each card to fully seat the card.
Step 6
Press down on the ejector levers to secure the card and connect it to the backplane.
Step 7
Use a flat-head screwdriver to turn the locking tab so that it overlaps the NI-2 card to prevent inadvertent
Step 8
dislodging, as shown in
Verify that the STATUS, ACTIVE, and POWER LEDs on the NI-2 card are solid green after the self-test
Step 9
is complete. This self-test procedure takes several minutes. If the STATUS LEDs are not green after the
self-test, see
Perform a software update if the STATUS LED on the NI-2 card is flashing. Refer to the appropriate
Step 10
software guide for your chassis for software upgrade procedures.
Attach the RX cable from the ATM switch to the TRNK 1 TX connector in the inset on the NI-2 card.
Step 11
See
Step 12
Attach the TX cable from the ATM switch to the TRNK 1 RX connector in the inset on the NI-2 card.
See
Note
Connect the Ethernet to the management network.
Step 13
Connect a VT100-compatible terminal to the NI-2 card CNSL connector.
Step 14
Cisco 6260 Hardware Installation Guide
6-16
shows the NI-2 installation in a Cisco 6260 chassis.
Figure
Chapter 5, "Troubleshooting,"
Figure 1-18
for the OC-3c network interface connection location.
Figure 1-18
for the OC-3c network interface connection location.
To cable the chassis for OC-3c subtending, see the installation chapter in this guide that
corresponds to your configuration.
Chapter 6
6-6.
for troubleshooting procedures.
Upgrading and Maintaining the Cisco 6260 System
OL-2365-02
Advertisement
Table of Contents
