Ds3+T1/E1 Ima Ni-2 Card Overview; Table 1-10 Ds3/2Ds3 Ni-2 Card Led Group Indicators - Cisco 6260 Installation Manual

Cisco 6260 System Overview
1. TRNK = trunk
2. SBTD = subtend
Table 1-10

Table 1-10 DS3/2DS3 NI-2 Card LED Group Indicators

LED Group
Interface
status LED
(5 in
Figure
System alarm
(6 in
Figure
Card status
(7 in
Figure
Fan alarm
(8 in
Figure
ENET
interface LED
(11 in
Figure
1. RX = receive
2. TX = transmit
3. RCLK = receive clock

1.2.3.10 DS3+T1/E1 IMA NI-2 Card Overview

The DS3+T1/E1 IMA NI-2 card
•
Cisco 6260 Hardware Installation Guide
1-32
describes the LED group indicators and their functions.
LED State
TEST Amber solid
Off
1-16)
1
RX STAT Amber solid
Off
2
TX STAT Amber solid
Off
3
RCLK Green solid
Off
CRITICAL Red
MAJOR Red
1-16)
MINOR Amber
POWER Green
STATUS Green
1-16)
ACTIVE Green
FAN 1 Red
1-16)
FAN 2 Off
ACT Green solid or
blinking
Off
1-16)
LNK Green solid
Provides the following network trunk and subtend interfaces:
Function
Cisco IOS detects that an obtrusive test (loopback) is
active on this interface.
Cisco IOS does not detect obtrusive test activity.
The receiver detects a physical layer problem.
The receiver does not detect a physical layer problem.
The transmitter detects a physical layer problem.
The transmitter does not detect a physical layer
problem.
Hardware detects an incoming clock signal.
Hardware does not detect an incoming clock signal.
A critical alarm is active.
A major alarm is active.
A minor alarm is active.
The NI-2 card has power.
The operational status of the NI-2 card.
On—There are no internal faults or problems.
•
Off—The NI-2 card has not booted properly, or a
•
problem is preventing normal operation.
The NI-2 card is operating as the active NI-2 card in
the chassis.
The fan module or fan tray is not operational and is in
alarm mode.
The fan tray is off.
The Ethernet interface is active.
The Ethernet interface is inactive.
The Ethernet link is connected and enabled.
Chapter 1 Product Overview
OL-2365-02