Alarms; Table 5-9 Chassis Alarm; Table 5-10 Card Slot Alarms; Table 5-11 Line Card Alarms - Cisco 6260 Installation Manual

Chapter 5 Troubleshooting

5.6 Alarms

Tables
is the text that appears in the description field of the alarm message. Alarm messages appear on the
console screen as the alarms occur; to see a list of current alarms, enter the show facility-alarm status
command.
Refer to the problem tables in this chapter for more detailed troubleshooting instructions.
Table 5-9
Alarm
Chassis temperature
too high

Table 5-10 Card Slot Alarms

Alarm
Provisioned slot is empty
Line card not equal
to provisioning
Invalid line card for
this slot

Table 5-11 Line Card Alarms

Alarm
ATU-C port failure
Upstream rate below
min. rate
Downstream rate below
min. rate
LOS, LOF, LOCD, or
LPR failure

Table 5-12 IOS Controller Alarms

Alarm
Loss of active clock sync
BITS clock failure
OL-2365-01
5-9 through 5-20 describe alarms for the Cisco 6260. In each table, the text in the Alarm column
Chassis Alarm
Severity
Major
Severity
Major
Minor
Minor
Severity
Minor
Minor
Minor
Minor
Severity
Major
Major
Description
A temperature too high for the safe operation of the
chassis has been detected. (Temperature is measured on
the NI-2 card.)
Description
The card in this slot does not match the type configured
for this slot.
This slot is configured for a card, but no card is present.
The card detected in this slot cannot operate in this slot or
is incompatible with the system configuration.
Description
The ATUC-DMT line card port failed.
The upstream bit rate on this port is not above the
configured minimum rate.
The downstream bit rate on this port is not above the
configured minimum rate.
The modem reports a near-end LOS, LOF, or LOCD or a
far-end LPR (loss of power) failure. (The line must be
enabled to alarm on failures.)
Description
Loss of timing reference. The configured clock source is
not available, so the system is using its internal clock.
BITS clock failure (LOS or AIS). The configured clock
source is not available, so the system is using its
internal clock.
Cisco 6260 Hardware Installation Guide
Alarms
5-17