Figure 1-1 Cisco 6260 Chassis Components; Chapter 1 Product Overview - Cisco 6260 Installation Manual

Introduction to the Cisco 6260 System
Figure 1-1
4
3
2
1
1
PEMs
2 Fan trays
xTU-C line cards (slots 1 to 9, 12 to 17, 18 to
26, and 27 to 32)
3
POTS splitters (optional). The POTS splitter is a passive device that supports simultaneous voice
•
(basic telephone service) and data services.
Note
Management software—Provisions and manages the Cisco 6260 system.
•
–
–
Cisco 6260 Hardware Installation Guide
1-2
Cisco 6260 Chassis Components
5 6
NI-2
-DS3/E3-DS3/E3
STATUS STATUS STATUS STATUS STATUS STATUS STATUS STATUS STATUS ACO
ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE
RESET
ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1
TRNK 1
ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2
TRNK 1
ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3
ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4
SBTD 2
SBTD 2
ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1
-4DMT -4DMT -4DMT -4DMT -4DMT -4DMT -4DMT -4DMT -4DMT
ALARMS
CRITICAL
MAJOR
MINOR
SBTD 3
SBTD 3 POWER
STATUS
ACTIVE
FAN 1
FAN 2
C
N
S
STATUS STATUS STATUS STATUS STATUS STATUS STATUS STATUS STATUS
L
ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE
A
U
ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1
X
ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2
ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3
E
ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 N
E
T
ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1
-4DMT -4DMT -4DMT -4DMT -4DMT -4DMT -4DMT -4DMT -4DMT
INPUT OK
OUT FAIL
FAN TRAY 1
FANTRAY 2
POTS splitters are available from Cisco Ecosystem partners. Please verify the compatibility with
your Cisco representative.
For POTS splitter information, refer to the vendor documentation.
Cisco IOS—A command-line interface (CLI) that is available for network
element provisioning.
Cisco DSL Manager (CDM)—An element management system designed to configure and
manage the 6xxx series of Cisco IOS software-based DSLAMs through a graphical-user
interface (GUI). CDM provides the following areas of network management: fault,
configuration, performance, and security. CDM runs within the Cisco Element Manager
Framework (EMF); both are installed on Sun workstations.
NI-2
-DS3/E3-DS3/E3
ACO STATUS STATUS STATUS STATUS STATUS STATUS
RESET ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE
ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1
ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2
TRNK 1
ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3
ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4
SBTD 2
ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1
-4DMT -4DMT -4DMT -4DMT -4DMT -4DMT
ALARMS
CRITICAL
MAJOR
MINOR
SBTD 3
POWER
STATUS
ACTIVE
FAN 1
FAN 2
C
N
S STATUS STATUS STATUS STATUS STATUS STATUS
L
ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE ACTIVE
A
U
ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1 ATU-C 1
X
ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2 ATU-C 2
ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3 ATU-C 3
E
N ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4 ATU-C 4
E
T
ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1 ATUC-1
-4DMT -4DMT -4DMT -4DMT -4DMT -4DMT
2
INPUT OK
OUT FAIL
FAN TRAY 1 1
FANTRAY 2
4
I/O module
5 Subscriber champ connectors
6 NI-2 card(s)
Chapter 1 Product Overview
OL-2365-02