Quad-Port Flexi Atu-C Line Card Overview - Cisco 6260 Installation Manual

Chapter 1 Product Overview
Table 1-4
LED
ATUC-1
ATUC-2
ATUC-3
ATUC-4

1.2.3.3 Quad-Port Flexi ATU-C Line Card Overview

The quad-port flexi ATU-C line card (4xflexi)
•
•
•
•
If provisioned, the 4xflexi rate adapts to the maximum bit rate negotiable on the line. The maximum bit
rate settings are provisioned in the management software.
The Cisco 6260 chassis can include up to 30 4xflexi line cards for a total of 120 ADSL
modem connections.
The edge connector key, located on the rear of the 4xflexi, connects the 4xflexi to the backplane of the
chassis. Two edge connector keys are available for the 4xflexi: one has six notches, and one has seven
notches. Only the seven-notched edge connector key can be installed in the Cisco 6260.
Note For hardware specifications for the 4xflexi, see the
page
OL-2365-02
4xDMT over ISDN LED Indicators (continued)
State
Green solid
Green blinking
Off
Green solid
Green blinking
Off
Green solid
Green blinking
Off
Green solid
Green blinking
Off
Supports DMT line encoding
Supports four ADSL modem connections
Converts ADSL modulation from the line into digital data streams to and from the NI-2 card
Negotiates the line rate with the CPE when it trains and bases the rate on line quality and distance
A-4.
Function
Modem 1 is trained.
Training is in progress for modem 1.
Modem 1 is idle.
Modem 2 is trained.
Training is in progress for modem 2.
Modem 2 is idle.
Modem 3 is trained.
Training is in progress for modem 3.
Modem 3 is idle.
Modem 4 is trained.
Training is in progress for modem 4.
Modem 4 is idle.
"Quad-Port Flexi ATU-C Line Card" section on
Cisco 6260 Hardware Installation Guide
Cisco 6260 System Overview
1-17