Cisco 6260 System Overview
Interface status LED groups: TRNK 1 and
SBTD 2, which show the status of the network
5
trunk and subtend connections.
Two optical interface connector pairs: TRNK
1 and SBTD 2
•
•
6
7
Model number
Table 1-12
Table 1-12 OC-3c/OC-3c NI-2 Card LED Group Indicators
LED Group
Interface
status LED
(5 in
Figure
System alarm
(7 in
Figure
Card status
(8 in
Figure
Cisco 6260 Hardware Installation Guide
1-38
TRNK 1—for network trunk interface TX
and RX data optical cables. On a
subtended node chassis, these TX and RX
cables connect to SBTD 2 on the
subtending host chassis.
SBTD 2—for subtended node chassis TX
and RX data optical cables.
describes the LED group indicators and their functions.
LED
State
TEST
Amber solid
Off
1-18)
RX STAT
Amber solid
Off
TX STAT
Amber solid
Off
RCLK
Green solid
Off
CRITICAL Red
MAJOR
Red
1-18)
MINOR
Amber
POWER
Green
STATUS
Green
1-18)
ACTIVE
Green
AUX—An RJ-45 receptacle that provides
connection to an auxiliary device (such as a
modem) used to remotely configure the
system.
12
ENET—An RJ-45 10BaseT receptacle that
complies with Ethernet standards and that
provides connection to a system Ethernet.
13
Function
Cisco IOS detects that an obtrusive test (loopback) is
active on this interface.
Cisco IOS does not detect obtrusive test activity.
The receiver detects a physical layer problem.
The receiver does not detect a physical layer problem.
The transmitter detects a physical layer problem.
The transmitter does not detect a physical layer
problem.
Hardware detects an incoming clock signal.
Hardware does not detect an incoming clock signal.
A critical alarm is active.
A major alarm is active.
A minor alarm is active.
The NI-2 card has power.
The operational status of the NI-2 card.
•
On—There are no internal faults or problems.
•
Off—The NI-2 card has not booted properly, or a
problem is preventing normal operation.
The NI-2 card is operating as the active NI-2 card in
the chassis.
Chapter 1
Product Overview
OL-2365-02