Download Print this page

Connect The Auxiliary Port; Complete Initial Configuration - Cisco 6160 Installation Procedures Manual

Without a pots splitter configuration

Advertisement

Chapter 4
Installing a Cisco 6160 Without a POTS Splitter Configuration
Table 4-2
Stop bits
Flow control
Warning
The ports labeled "ENET," "CNSL," and "AUX" are safety extra-low voltage (SELV) circuits. SELV
circuits should be connected only to other SELV circuits. Because the DSL circuits are treated like
telephone-network voltage, avoid connecting the SELV circuit to the telephone network voltage (TNV)
circuits.

4.2.14 Connect the Auxiliary Port

This step is optional.
Note
Connect a terminal, a modem, or another serial device to the RJ-45 auxiliary port (AUX) on the NI-2
card faceplate.
The ports labeled "ENET," "CNSL," and "AUX" are safety extra-low voltage (SELV) circuits. SELV
Warning
circuits should be connected only to other SELV circuits. Because the DSL circuits are treated like
telephone-network voltage, avoid connecting the SELV circuit to the TNV circuits.
Cisco recommends that you label each data cable at both ends to identify its destination.
Tip

4.2.15 Complete Initial Configuration

When you turn on the Cisco 6160 for the first time, the System Configuration Dialog appears on the
console screen. The System Configuration Dialog guides you through the initial configuration process.
(You can run the dialog at any time by entering the setup command in privileged EXEC mode.)
When you complete the dialog, the system displays the configuration command script that you have
created. It then offers you three options:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you enter 2, the configuration is saved and used. If you answer 0 or 1, the configuration you created is
not saved. Enter 1 if you wish to discard the configuration and restart the System Configuration Dialog.
OL-2190-02 B0
Terminal Settings (continued)
1
None
Installation Procedures
Cisco 6160 Hardware Installation Guide
4-25

Advertisement

loading