Telnet Command: Ip6 Dhcp Server - Draytek Vigor2860 series User Manual

client
[<command>
<parameter>|...]
-a
-p [IAID]
-n [IAID]
-c [parameter]
-i [parameter]
-e[parameter]
E x a m p
E x a m p
> ip6 dhcp client WAN2 –p 2008::1
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
> ip6 dhcp client WAN2 –n 1023456
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
> system reboot
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure DHCPv6 server.
ip6 dhcp server [-<command> <parameter>| ... ]
S S y y n n t t a a x x
Parameter
server
[<command>
<parameter>|...]
-a
-<pool_min_addr>
-x<pool_max_addr>
-d<addr>
Vigor2860 Series User's Guide
l e
l e
DHCPv6 client enabled
request IA_PD whose IAID equals to 2008
DHCPv6 client enabled
request IA_NA whose IAID equals to 2008
a n d : i p 6 d h c p s e
a n d : i p 6 d h c p s e
D D e e s s c c r r i i p p t t i i o o n n
Description
It means the dhcp server settings.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one
line.
It means to show current DHCPv6 status.
It means to set the start IPv6 address of the address pool.
It means to set the end IPv6 address of the address pool.
It means to set the first DNS IPv6 address.
It means the dhcp client settings.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one
line.
It means to show current DHCPv6 status.
It means to request identity association ID for Prefix
Delegation.
It means to request identity association ID for
Non-temporary Address.
It means to send rapid commit to server.
It means to send information request to server.
It means to enable or disable the DHCPv6 client.
1: Enable
0: Disable
r v e r
r v e r
596