Telnet Command: Wl Set - Draytek Vigor2860 series User Manual

E x a m p
E x a m p
> wl config mode 11bgn
Current mode is 11bgn
% <Note> Please restart wireless after you set the channel
> wl config channel 13
Current channel is 13
% <Note> Please restart wireless after you set the channel.
> wl config preamble 1
Long preamble is enabled
% <Note> Please restart wireless after you set the parameters.
> wl config ssid 1 enable dray
SSID Enable Hide_SSID Name
1
% <Note> Please restart wireless after you set the parameters.
> wl config security 1 wpa1x
%% Configured Wlan Security Setting:
% SSID1
%% Mode: wpa1x
%% Wireless card must be reset for configurations to take effect
%% (Telnet Command: wl restart)
T e l n e t C o m m
T e l n e t C o m m
This command allows users to configure basic wireless settings.
wl set [SSID] [CHAN[En]]
wl set txburst [enable]
S y n t a x
S y n t a x
Parameter
SSID
CHAN[En]
txburst [enable]
E E x x a a m m p p
> wl set MKT 2 on
% New Wlan Setting is:
Vigor2860 Series User's Guide
same SSID not accessing for each other.
l e
l e
1 0
a n d : w l s e t
a n d : w l s e t
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to type the SSID for the router. The maximum
character that you can use is 32.
It means to specify required channel for the router.
CHAN: The range for the number is between 1 ~ 13.
En: type on to enable the function; type off to disable the
function.
It means to enhance the performance in data transmission
about 40%* more (by enabling Tx Burst). It is active only
when both sides of Access Point and Station (in wireless
client) invoke this function at the same time.
0: disable the function.
1: enable the function.
l l e e
dray
708