Telnet Command: Wan Vdsl; Telnet Command: Wan Detect - Draytek Vigor2860 series User Manual

TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
PVC_WAN4: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
PVC_WAN5: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows you to configure display current VDSL status and configure the
fallback mode for WAN connection.
wan vdsl [show basic]
wan vdsl[fbk_mode]
S y n t a x D e
S y n t a x D e
Parameter
show basic
fbk_mode
E x a m p l e
E x a m p l e
> wan vdsl show basic
ADSL
Link Status:
Firmware Version:
ADSL Profile:
Basic Status Upstream
Actual Data Rate:
SNR:
> wan vdsl fbk_mode vdsl_only
Set VDSL fallback mode to VDSL ONLY
Reboot system to take effect
>
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows you to Ping a specified IP to detect the WAN connection (static IP or
PPPoE mode).
wan detect [wan1][on/off/always_on]
wan detect [wan1]target [ip addr]
: w a n v d s l
: w a n v d s l
s c r i p t i o n
s c r i p t i o n
Description
It means to display current VDSL status.
It means to display current status of Fallback Mode used.
Available modes to be set as fallback mode include,
Auto
Vdsl_only
Adsl_only
TRAINING
05-04-04-04-00-01
0
0 0 0.1dB
: w a n d e t e c t
: w a n d e t e c t
Downstream
0 Kb/s
701
Unit
Vigor2860 Series User's Guide