Rear Master Cylinder Installation - Honda CRF450X 2005 Service Manual

(
BB
ceffllin
the snap
rinr;
IS
firmly seared
in the groove.
Install the push rod into the master cylinder.
Install the snap ring using the special tool.
TOOL:
Snap ring pller 07914·SA50001
Apply silicone grease to the boot fining area.
Install the boot.
HYDRAULIC BRAKE
SNAP RING
Adjust the brake pedal to the desired height by 100s- , - - - - - - - - - -- - - - - ----,
ening the lock nut and turning the adjuster. ADJUSTER
STANDARD LENGTH : 79.6 mm (3 ,13 In)
Tighten the lock nul to the specified torque.
TORQUE: 5.9 N'm (0.6 kgf·m, 4.4 Ibf.ft)
INSTALLATION
Install the master cyli nder and tighten the mount ing
bolts to the specified torque.
TORQUE: 13 N' m (1.3 kgf·m, 10 Ibf.ftl
LOCK NUT
Install the brake hose with the oil bolt and new seal-
~:.:~~
.....
~
ing washers.
Push the eyelet joint against the stopper, then
tighten the brake h ose oil bolt to the specified
torque.
TORQUE: 34 N ·m !3.5
kgf·m,
25
Ibf·ftJ
Insta ll the brake pedal (page 16·24).
Fill and bleed the rear brake hydraulic system (page
16-7).
79.6
mm
(3.13
in)
16-17