Back Panel Connectors - Cisco Prisma II Hybrid Amplifier Installation Manual

Chapter 1 Module Introduction
Part
Laser Aperture Out
Laser Aperture In
-20 dB Laser Aperture Out
Test Point

Back Panel Connectors

Blind-mate connectors make it easy to install this module. The push-on connector on
the back of the module mates with the back plane bus connector inside the chassis.
This 110-pin connector provides the following:
Electrical power input connection

Alarm communications

Status-monitoring communications

Communications and control connections

6
Function
Connects the output signal to the optical cable. The optical
outputs are divided into two banks, A and B.
Connects the optical cable input signal to the module
inputs.
Provides a -20 dB sample of the optical output signal
relative to the bank B optical outputs.
78-4025693-01 Rev D