Cisco Prisma II Hybrid Amplifier Installation Manual page 77

Show Provisioning
This command displays a list of the CLI commands needed to restore any
replacement modules in the ICIM domain to their current operating states. This list
can serve as a command reference to quickly configure a replacement module so that
it operates identically to the original.
The output is intended primarily for use by a network management system, which
would store the provisioning commands until needed. In the event that a module is
replaced, the system would then send the provisioning commands required to
configure the replacement module to match the operating state of the original.
The following sample dialog shows how a network management system might send
the command, and includes a portion of a typical response.
CLI> icim show provisioning exit
. . . .
Module Chassis 20 Slot
Module Chassis 20 Slot
Module Chassis 20 Slot
Module Chassis 20 Slot
Module Chassis 20 Slot
Module Chassis 20 Slot
Module Chassis 20 Slot
. . . .
Using the list requires first locating all command lines that target the chassis and slot
location of the replacement module. The commands are then sent to the replacement
module one at a time in the order listed. For example, after replacing the module in
chassis 20 slot 6 in the above example, the commands on lines 6-9 of the response
would be sent to configure the replacement module.
Note: The CLI has no mechanism for accepting multiple commands at a single
prompt from either a craft operator or a network management system. It is necessary
to send the first command, wait for a new prompt, send the next command, and so
on until all commands are sent.
Show Traps
This command is used to display the current status of the Trap table. The basic
syntax is as follows:
show traps
78-4025693-01 Rev D
5 Set Control Enable
5 Set Control AGC
5 Set Control RFDrive 0
5 Set Control OMISet
5 Set Control Master
5 Set Control CWMode
5 Set Control LenMode Off
On EXIT
On EXIT
EXIT
0 EXIT
Master EXIT
Off EXIT
EXIT
ICIM Commands
51