Headers Command - Cisco Prisma II Hybrid Amplifier Installation Manual

The Regex pattern matching style includes a much more powerful, but also more
complex, pattern matching format, a description of which is beyond the scope of this
document. For further information, refer to resources available on the public internet
for Perl or Boost, such as:
http://perldoc.perl.org/

http://www.boost.org/


Headers Command

The headers command is used to enable or disable the display of column headers
that may appear in CLI output. The basic command syntax is as follows:
headers value
where value is 0 to disable header display, and 1 (or any number other than 0) to
enable header display.
Headers are enabled (1) by default, as shown in the sample craft operator dialog
below:
20/03 MODULE> show monitor ps*5* <Enter>
MODID
20/03
20/03
20/03
20/03
SUCCESS!
20/03 MODULE>
To following sample dialog shows how a craft operator might disable the column
headers and confirm the change:
20/03 MODULE> terminal <Enter>
TERMINAL> headers 0 <Enter>
TERMINAL> module modid 2003 <Enter>
20/03 MODULE> show monitor ps*5* <Enter>
20/03
20/03
20/03
20/03
SUCCESS!
20/03 MODULE>
78-4025693-01 Rev D
NAME VALUE UNITS
Ps1+5V 0 V
Ps1-5V 0 V
Ps3+5V 5.39218 V
Ps3-5V -5.43724 V
Ps1+5V 0 V
Ps1-5V 0 V
Ps3+5V 5.39218 V
Ps3-5V -5.43724 V
Terminal Commands
61