The Back of the Module
Back of the Module Connectors
Blind-mate connectors make it easy to install this module. The connector on the back
of the module mates with a connector inside the chassis. The 110-pin connector
provides the following:
Electrical power input connection
•
Alarm communications connection
•
Status-monitoring communications
•
Communications and control connections
•
Power and Communications Connector
The power and communications connector on the back of the module mates with a
connector inside of the chassis, and supplies power from the chassis to the module.
The 110-pin connector also routes alarm and status-monitoring information from the
transmitter to the Prisma II Chassis.
1-6
Introduction
78-4006323-01 Rev C