Set Command - Cisco Prisma II Hybrid Amplifier Installation Manual

Chapter 3 Operation Using CLI
A typical response to this command is shown in the sample craft operator dialog
below:
CLI> icim <Enter>
ICIM> show traps
IDX STATE
0 Enabled
1 Enabled
2 Enabled
3 Disabled
4 Disabled
SUCCESS!
ICIM>
Show Clock
Note that the show command supports access to the ICIM real time clock (RTC), as
follows:
ICIM> show clock exit
MM-DD-YYYY
11-15-2005
SUCCESS!
ICIM>

Set Command

The set command allows a single value to be set in the ICIM. The basic syntax is:
set argument value
Where argument is one of the values listed in the following table.
Value
CLLI
CLOCK
COMMREAD
COMMWRITE
COMMTRAP
GATEWAY
IP
STATUSMSG
SUBNET
UPDATEID
Some of these values (IP and GATEWAY, for example) result in changes to the ICIM
NVRAM, but do not take effect until the next reboot.
52
IP Address
172.18.50.41
172.18.50.1
172.18.50.6
0.0.0.0
0.0.0.0
HH:mm:ss
12:01:40
Function
Common Language Locator ID code for the ICIM
Date and Time as maintained by the ICIM
SNMP Read Community string
SNMP Write Community string
SNMP Trap Community string
IP address of the TCP/IP gateway, for packet routing
TCP/IP address of the ICIM
Error or Status message
Subnet mask, such as 255.255.255.0
Write-only; value of 1 causes ICIM to re-read ID of all modules
78-4025693-01 Rev D