Table of Contents
Advertisement
Chapter 3 Operation Using CLI
ICIM Commands
ICIM commands provide for monitoring and control of the ICIM itself and for the
ICIM domain in general.
Alarm Command
The alarm command is used to display all active alarms in the domain of the ICIM.
The following sample dialog illustrates the use of this command:
ICIM> alarm <Enter>
No active alarms found
SUCCESS!
ICIM>
This response indicates that no alarms are currently active anywhere in the ICIM
domain. To narrow the command scope to specific chassis or modules, use this
command in Module mode together with the module option, as described in Module
Commands (on page 38).
Info Command
The info command is used to request a listing of one or more parameter values
specific to the ICIM module itself.
The general command syntax is as follows:
info argument argument ... argument
where each argument can have one of the values listed in the table below.
Value
ACTIVEREV
ATTNSTATUS
BOOTREV
CHASSIS
CLEI
CLLI
COMMREAD
COMMTRAP
COMMWRITE
DEVTYPE
DOWNLDCMD
48
Function
Active software image revision for the ICIM
Value for the Attention line (Low is normal)
Current boot image revision for the ICIM
Chassis containing the ICIM
Common Language Equipment ID code for the ICIM
Common Language Locator ID code for the ICIM
Sets the SNMP Community Read string
Sets the SNMP Community Trap string
Sets the SNMP Community Write string
Devtype for the ICIM2 or ICIM2-XD
Download command (used by SOUP)
78-4025693-01 Rev D
Advertisement
Table of Contents
Troubleshooting
