To Restart The Icim By Removing The Icim - Cisco Prisma II Hybrid Amplifier Installation Manual

To Restart the ICIM by Removing the ICIM

Unscrew the captive screw near the top right-hand corner of the ICIM.
1
2 Unlock the top and bottom ejector levers near the left-hand side of the ICIM.
3 Pull the ejector levers out and away from the front panel to disconnect the ICIM
from the chassis backplane connector.
4 Pull the ICIM at least 1.5 inches (3.81 cm) out from the front of the chassis to
ensure that it is fully separated from the chassis backplane connector.
Reinsert the ICIM into the chassis until the ejector levers insert into their
5
respective slots in the chassis.
Push the ejector levers in and flat against the ICIM front panel to reconnect the
6
ICIM to the backplane connector until the ejector levers lock in place.
Screw in the captive screw to secure the ICIM in the chassis.
7
78-4025693-01 Rev D
SNMP Configuration
93