Cisco Prisma II Hybrid Amplifier Installation Manual page 45

3 At the command prompt, type:
telnet <IP address>
where
Login prompt appears.
4 At the Login prompt, type Administrat0r (note the zero character in the string),
and then press Enter.
5 At the Password prompt, type AdminPassw0rd (note the zero character in the
string), and then press Enter.
6 At the telnet> prompt, type cli, and then press Enter. The CLI> command
prompt appears.
7 Enter the module configuration commands as indicated above.
8 Type logout and then press Enter to exit the session.
78-4025693-01 Rev D
is the IP address of the ICIM. The session starts and the Telnet
IP address
Installing the Module in the Chassis
19