Viewing All Channels With Sequence Mode; Basic Sequence Mode - Honeywell HNDR-S4824 User Manual

Basic Configuration HNDR-S4824

3.4. Viewing all channels with sequence mode

There are two modes; basic sequence mode and user sequence mode. User sequence mode runs when
pressing the [SEQ] button during 1 second or above.

3.4.1. Basic sequence mode

- All channels can be viewed in successive order automatically using the [SEQ] button.
- Press the [MENU] button on the front panel to set-up the sequential cycle. (The default value is 3
seconds per channel for display.)
- Select "Monitor A" menu of "Monitor" tab among Configuration menus. And press the [ENTER] button.
- Select "Seq. Switching(sec)" and set any value between 1 and 60 seconds.
- In order to move to sequence mode from any viewer mode, press the [SEQ] button.
- In order to exit from sequence mode, press the [SEQ] button once again.
<Note>
Sequence mode can run only when connected and activated cameras are more than split screen. With
single full screen mode, activated cameras should be two or more. With quad-split screen mode, there
should be five or more activated cameras. In 16 / 13 spilit mode, sequence mode can't be used.
Honeywell 13
2004.05.31 (v 2.0)