Honeywell HNDR-S4824 User Manual page 55

Basic Configuration HNDR-S4824
DHCP can also be used for xDSL (PPPoE) interface. Sometimes, all computers on a Local Area Network
(LAN) share a single Floating / Dynamic IP address. In this case, the HNDR-S4824 should be assigned a
private IP address and have DHCP enabled. Users on the LAN can connect to the HNDR-S4824 using the
private IP address and outside users can connect to the HNDR-S4824 over the Internet.
IP Address, NetMask, and Gateway Address, DNS
Administrator may configure IP address, subnet mask, gateway address, and DNS addresses of HNDR-
S4824.
5.7.6.2. xDSL
If HNDR-S4824 is connected on xDSL line and needs PPPoE process, the network administrator
should configure the user ID and password for PPPoE. ID. The password may be acquired from the
ISP that installed the line. Once configured, the HNDR-S4824 will receive an IP address when it is
connected on xDSL line.
User ID/Password
When HNDR-S4824 is connected to xDSL, access ID and Password should be entered.
Status
Displays the HNDR-S4824 connection status.
Honeywell 55
2004.05.31 (v 2.0)