Honeywell HNDR-S4824 User Manual page 34

HNDR-S4824 Basic Configuration
Status
Set "On/Off" using the ◄ or ► button after pressing the [ENTER] button.
Type
Just displays the video-input signal. It is set with jumper switch inside of HNDR-S4824.
HNDR-S4824 recognizes video signal (NTSC/PAL) automatically with booting. Namely the first
recognized video signal is set after checking Ch 1 to 16. If camera is not connected, it follows jumper
setting value.
Color
Set "Color/ B/W" using the ◄ or ► buttons.
AGC (Auto Gain Control)
Set "Enable/Disable" using the ◄ or ► buttons after pressing the [ENTER] button.
Brightness/Contrast
Set the value between –9 and +9 using the ◄ or ► buttons after pressing the [ENTER] button.
Covert
If setting "Covert" as "On", channel will be hidden in monitoring mode.
Set "A / B / Both / Off" using the ◄ or ► buttons after pressing the [ENTER] button.
PTZ Home/PTZ Idle Time
If there is not any movement during "PTZ Idle Time", the camera will move to the already desingnated
preset point.
Set the preset number and time with using the ◄ or ► buttons.
PTZ Port
Set the value using the ◄ or ► buttons.
Address
Press the [ENTER] button to open the dialogue box for setting base address of PTZ device.
34 Honeywell
2004.05.31 (v 2.0)