Controlling And Monitoring A Call - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set
AdministrAtor guide
Table of contents Introduction
Controlling and monitoring a call
You can control and monitor several call features using the
Call Control page.
Adjusting the sound volume
Use + and - on the volume control bar to adjust the sound
volume of your system (not the keyboard
Muting the microphone
Use the Mute button when you want to deactivate the
microphone for privacy reasons.
When the microphone is muted, the button is replaced by an
Unmute button. Use this button to re-activate the microphone.
Controlling the camera
First, press the Camera Control button. Then, in the window
that opens, use + and - to adjust the zoom and the arrow keys
to adjust the camera's angle.
If a camera preset is defined it is listed to the right. Apply the
preset by clicking its name.
Call settings
When you load the Call Control page, the default call bit rate
and the default call protocol are shown in the
Call protocol fields, respectively. If preferred, you can select
another bit rate or another protocol from the drop down lists.
You can not change these settings during a call.
Call details
Press Show details while in a call to provide information on
call rate, encryption, as well as important video and audio
parameters.
Hide details removes the information.
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved.
Web interface Web interface
+ and - keys).
Call bit rate and
Show/hide
call details
Call bit rate
Call protocol
Call Control
Advanced settings Appendices
17
Volume control
Microphone mute
Camera control
www.cisco.com