Cisco TelePresence SX20 Quick Set Administrator's Manual page 44

Cisco TelePresence SX20 Quick Set
AdministrAtor guide
Table of contents Introduction
Network [1..1] VLAN Voice Mode
Set the VLAN voice mode.
Requires user role: ADMIN
Value space: <Auto/Manual/Off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If
CDP is not available, VLAN is not enabled. The VLAN Voice Mode automatically will be set to
Auto when the GUI is used to set the Provisioning Mode to CUCM.
Manual: The VLAN id is set manually using the Network VLAN Voice VlanId setting. If CDP is
available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.
Example: Network 1 VLAN Voice Mode: Off
Network [1..1] VLAN Voice VlanId
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requires user role: ADMIN
Value space: <1..4094>
Range: Select a value from 1 to 4094.
Example: Network 1 VLAN Voice VlanId: 1
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings Advanced settings Appendices
44
www.cisco.com