Cisco TelePresence SX20 Quick Set Administrator's Manual page 36

Cisco TelePresence SX20 Quick Set
AdministrAtor guide
Table of contents Introduction
Conference [1..1] PacketLossResilience Mode
Set the packetloss resilience mode. This configuration will only take effect for calls initiated after
the configuration is set.
Requires user role: ADMIN
Value space: <On/Off>
On: Enable the packetloss resilience.
Off: Disable the packetloss resilience.
Example: Conference 1 PacketLossResilience Mode: On
Conference [1..1] Presentation Policy
Control how the presentation service is to be performed.
Requires user role: ADMIN
Value space: <LocalRemote/LocalOnly>
LocalRemote: The presentation will be shown locally and sent to remote side.
LocalOnly: The presentation will only be shown locally.
Example: Conference 1 Presentation Policy: LocalRemote
Conference [1..1] Multipoint Mode
Define how the video system handles multipoint video conferences. Basically there are two
ways: The video system can use its built-in MultiSite feature (optional), or it can rely on the
MultiWay network solution. MultiWay requires that your video network includes an external
Multipoint control unit (MCU). The MultiSite feature allows up to four participants (yourself
included) plus one additional audio call. An External MCU may let you set up conferences with
many participants.
Requires user role: ADMIN
Value space: <Off/MulitSite/MultiWay/Auto>
Off: Multipoint conferences are not allowed.
MultiSite: Use MultiSite for multipoint conferences. If MultiSite is chosen when the MultiSite
feature is not available, the Multipoint Mode will be set to Off.
MultiWay: Use MultiWay for multipoint conferences. The Multipoint Mode will be set to
Off automatically if the MultiWay service is unavailable, e.g. when a server address is not
specified in the NetworkServices MultiWay Address setting.
Auto: If a MultiWay address is specified in the NetworkServices Multiway Address setting,
MultiWay takes priority over MultiSite. If neither MultiWay nor MultiSite is available, the
multipoint mode is set to Off automatically.
Example: Conference 1 Multipoint Mode: Auto
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings Advanced settings Appendices
Conference [1..1] IncomingMultisiteCall Mode
Select whether or not to allow incoming calls when already in a call/conference.
Requires user role: ADMIN
Value space: <Allow/Deny>
Allow: You will be notified when someone calls you while you are already in a call. You can
accept the incoming call or not. The ongoing call may be put on hold while answering the
incoming call; or you may merge the calls (requires MultiSite or MultiWay support).
Deny: An incoming call will be rejected if you are already in a call. You will not be notified
about the incoming call. However, the call will appear as a missed call in the call history list.
Example: Conference 1 IncomingMultisiteCall Mode: Allow
36
www.cisco.com