Status And Informational Events; Event Code Definitions - GE MDS SD Series Technical Manual

90
Minor Alarms report conditions that, under most circumstances will not
prevent transceiver operation. This includes out-of-tolerance conditions,
baud rate mismatches, etc. The cause of these alarms should be investi-
gated and corrected to prevent system failure.

Status and Informational Events

Status events indicate current states or conditions that are not errors.
They are used merely to indicate process functions (i.e.,
).
Process
Informational (Inform) events pertain to those items which have
occurred since bootup. They may or may not indicate an error, and they
do not show current conditions, just an event that occurred at some point
after boot-up (i.e., Event #32

Event Code Definitions

Table 15 contains a listing of event codes that may be reported by the
transceiver. The codes shown are a subset of a larger pool of codes used
for various GE MDS products. For this reason, the table does not show
a sequential listing of all code numbers. Only the codes applicable to
this product series are shown. This list is subject to change with product
revision.
Event Event
Code Class Description
000 Major Not currently implemented.
001 Major Not currently implemented.
002 Major Frequency not programmed.
003 Major Authorization fault detected.
004 Major RF synthesizer out-of-lock condition.
005 Major Not currently implemented.
006 Major Not currently implemented.
007 Major Not currently implemented.
008 Major Radio not calibrated. Factory calibration is required for proper
operation.
009 Major DSP download fault.
010 Major Not currently implemented.
011 Major Not currently implemented.
012 Major Receiver time-out. No data received within the specified
receiver time-out time.
013 Major Transmitter time-out.
014 Major Alarm Test.
015 Major Not currently implemented.
068 Major Excessive Ethernet traffic on interface.
SD Series Technical Manual
).
Booting Up
Table 15. Event Codes
Reprogramming in
MDS 05-4846A01, Rev. H