GE MDS SD Series Technical Manual page 50

42
Table 11. Device Manager Quick Reference (Continued)
Task
If you wish to...
Category
View logged Events
Set alarm signal output (active high/low)
Conduct an Alarm Test
View I/O Statistics for COM1, COM2, Ethernet
Port, Remote Programming, Ethernet Interface,
Data Link Layer, and MAC.
View MAC Routes
The remainder of this section covers the screens for
Maintenance and Status
selections, how to access them, and their effect on radio operation. If
you are unsure of the setting required for a particular radio in your net-
work, consult your Network Administrator for assistance.
NOTE: The Device Manager screens shown in this manual were
obtained from a radio operating in a lab environment and are
provided as examples only. Not all content will be legible in
these reduced size examples. Also, the parameters and settings
shown may differ from those seen in field service conditions.
SD Series Technical Manual
of the transceiver. The emphasis is on available
Refer to this Screen/Section
Maintenance & Status>>
Event Log, Page 73
Maintenance & Status>>
Alarm Summary>>
Alarm Signal Configuration,
Page 74
Maintenance & Status>>
Radio Test>>
Alarm Test, Page 80
Maintenance & Status>>
Performance>>
I/O Statistics, Page 76, and
Ethernet Statistics, Page 76
Maintenance & Status>>
Performance>>
MAC Routes, Page 77
, and
Configuration
MDS 05-4846A01, Rev. H