GE MDS SD Series Technical Manual page 112

102
DATA CHARACTERISTICS
Signaling Types:
COM2 Data Rates:
Data Latency:
PRIMARY POWER
Voltage:
NOTE: Early SD4 models supported 10.5 to 16 Vdc power, not 10 to 30 Vdc. Check the labeling
above the power connector to confirm the operating range for your unit.
TX Supply Current (Typical):
RX Supply Current (Typical):
Fuse:
ENVIRONMENTAL
Humidity:
Temperature Range:
Duty Cycle:
Weight (nominal):
Transceiver Dimensions:
Mean Time Between Failure
(MTBF):
DIAGNOSTICS INTERFACE
Signaling Standard:
Product specifications are subject to change without notice or obliga-
tion to any party.
SD Series Technical Manual
RS-232/485; DB-9 Female connector
Ethernet 10/100 Mbps; RJ-45F connector
300–115200 bps, asynchronous
11 ms typical (transparent)
10.0 to 30 Vdc (Negative ground only)
2.5 Amperes maximum @ 5 Watts RF Output
Operational—125 mA, Nominal
Sleep—<10 mA typical @ 13.8 Vdc
5 Ampere, internal
95%, non-condensing
–40 to 70 degrees C (–40°F to 158°F)
50% (ambient temperature, -40C to +70C)
Continuous (internal temperature <= +80C)
1.22 lbs. (0.55 kg)
6.5" long (16.51 cm), 4.625" wide (11.75 cm),
1.5" High (3.81 cm)
Consult factory for on-file data
RS-232 (COM1, DB-9F connector)
RS-232/RS-485 (COM2, DB-9F connector)
MDS 05-4846A01, Rev. H