GE MDS SD Series Technical Manual page 39

Using the Basic
Setup Wizard
MDS 05-4846A01, Rev. H
4. The Basic Setup Wizard (Figure 24) begins automatically upon con-
nection to a new factory shipped radio. It may also be started manu-
ally by selecting
Setup Wizards>>Basic Setup
Wizard displays a series of screens with key selections as follows:
• TX/RX Frequencies
• System ID
• RF Output Power
• Radio Mode
• Modem Type (Transparent or Packet w/MAC)
• Com 2 Port Baud Rate
• Bridge Mode
• Encryption Mode
• DLINK Passphrase
• Device Type
• Ethernet Settings
TX and RX frequencies may not be set when the radio is
NOTE:
shipped from the factory, depending on ordering options. If no
frequencies have been set, an alarm condition is generated and
the LED flashes. These will be cleared after the frequen-
PWR
cies are set. In all cases, users must verify that the frequencies
are properly set according to the station license.
Operation on exact multiples of 25 MHz is not supported by
NOTE:
the SDx transceiver (i.e., 400, 425, 450, 475, and 500 MHz).
The option to configure the Radio Mode is also available under
NOTE:
Configuration >> Radio
Continue through each wizard screen until all selections have been
made. (You may back up to previous screens if required, to review or
change settings.) If you are unsure about a required setting, contact
your Network Administrator for assistance.
SD Series Technical Manual
Invisible place holder
Figure 23. Login Screen
, and then clicking
under
Device Settings
. The
Start
.
31