Accessories And Spares; Protected Network Station - GE MDS SD Series Technical Manual

8

2.5 Accessories and Spares

Table 1 lists common accessories and spare items for the transceiver.
GE MDS also offers an Accessories Selection Guide listing additional
items that may be used with the product. Visit
your factory representative to obtain a copy of the guide.
Table 1. Accessories & Spare Items
Accessory
Retrofit Kit, Digital
Retrofit Kit, Analog
DC Power Plug,
2-pin, polarized
Setup Guide
(for Packet and
Transparent Modes)
Flat Mounting
Bracket Kit
DIN Rail Mounting
Bracket Kit

Protected Network Station

The transceiver is available in a protected network configuration, known
as the SDxP (Figure 4), where x denotes the particular model of SD
transceiver installed inside the chassis (i.e., SD1, 2, 4, 9, etc.).
The SDxP is a tabletop or rack-mount unit designed to hold two trans-
ceivers, two power supplies, and a switchover logic board that automat-
ically selects between transceiver A or B as the active unit. Manual
selection may also be made using a front panel switch.
SD Series Technical Manual
Description
Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS x710A/C/M
digital transceiver.
Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS x710A/C/M
analog transceiver.
Mates with power connector on radio
case. Screw terminals provided for
wires, threaded locking screws to
prevent accidental disconnect.
Describes the installation and setup
of the transceiver. A companion to
this Technical Manual.
Brackets that attach to the bottom of
the unit. Used for mounting to a flat
mounting surface. Fits the mounting
footprint of MDS x710 transceivers.
Contains bracket for mounting the
transceiver to standard 35 mm DIN
rails commonly used in equipment
cabinets and panels.
or contact
www.gemds.com
Part Number
03-4696A01
03-4697A01
73-1194A53
05-4847A01
03-4123A14
03-4125A04
MDS 05-4846A01, Rev. H