Using The Show Controllers Commands - Cisco 2950 - Catalyst Switch Configuration Manual

Using the show controllers Commands

Command
Step 5 end
Step 6
show auto qos interface interface-id
For more information about auto-QoS, see the
This example shows how to display the QoS commands that are automatically generated when auto-QoS
is enabled:
Switch# debug auto qos
AutoQoS debugging is on
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# auto qos voip cisco-phone
Using the show controllers Commands
You can display the statistics, configuration, and other information about the Catalyst 2950 LRE switch,
the connected CPE devices, and the LRE link. Use the privileged EXEC commands in
display this information:
Table 32-3 Commands for Displaying LRE and CPE Information
show controllers ethernet-controller
interface-id [asic | cpe [port port-id] | phy]
show controllers lre cpe {identity | mfg |
protected | version} [interface-id]
show controllers lre
show controllers lre log
For more information about the fields in the command output, refer to the switch command reference for
this release.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
32-22
Purpose
Return to privileged EXEC mode.
Verify your entries.
This command displays the auto-QoS configuration that was initially
applied; it does not display any user changes to the configuration that
might be in effect.
"Configuring Auto-QoS" section on page
Displays per-interface transmit and receive statistics read from the hardware,
the interface internal registers, and the statistics read from LRE and CPE
ports.
Displays information about the Cisco LRE CPE devices connected to an
LRE switch.
Displays information about the LRE link.
Displays the history of the link, configuration, and timer events for a specific
LRE interface or for all the LRE switch interfaces.
End with CNTL/Z.
Chapter 32 Troubleshooting
30-9.
Table 32-3 to
78-11380-10