Cisco 2950 - Catalyst Switch Configuration Manual page 530

Configuring SNMP
Table 28-4 Switch Notification Types (continued)
Notification Type
Keyword
cluster
config
copy-config
entity
envmon
flash
hsrp
mac-notification
port-security
rtr
snmp
stpx
syslog
tty
vlan-membership
vlancreate
vlandelete
vtp
Some notification types cannot be controlled with the snmp-server enable global configuration
command, for example, tty and udp-port. These notification types are always enabled. You can use the
snmp-server host global configuration command to a specific host to receive the notification types
listed in
Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs
to a host:
Command
Step 1
configure terminal
Step 2 snmp-server engineID remote
ip-address engineid-string
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
28-12
Description
Generates a trap when the cluster configuration changes.
Generates a trap for SNMP configuration changes.
Generates a trap for SNMP copy configuration changes.
Generates a trap for SNMP entity changes.
Generates environmental monitor traps. You can enable any or all of these
environmental traps: fan, shutdown, supply, temperature.
Generates SNMP FLASH notifications.
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
Generates a trap for MAC address notifications.
Generates SNMP port security traps. You can also set a maximum trap rate
per second. The range is from 0 to 1000; the default is 0, which means that
there is no rate limit.
Generates a trap for the SNMP Response Time Reporter (RTR).
Generates a trap for SNMP-type notifications.
Generates SNMP STP Extended MIB traps.
Generates SNMP syslog traps.
Sends Cisco enterprise-specific notifications when a Transmission Control
Protocol (TCP) connection closes.
Generates a trap for SNMP VLAN membership changes.
Generates SNMP VLAN-created traps.
Generates SNMP VLAN-deleted traps.
Generates a trap for VLAN Trunking Protocol (VTP) changes.
Table 28-4.
Purpose
Enter global configuration mode.
Specify the engine ID for the remote host.
Chapter 28 Configuring SNMP
78-11380-10