Cpe Ethernet Link Guidelines; Guidelines For Configuring Cisco 575 Lre Cpes And 576 Lre 997 Cpes - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 13 Configuring LRE
•
•
Use the show controllers lre status link privileged EXEC command to display the LRE link statistics
and profile information on the LRE ports. For information about this command, refer to the switch
command reference.

CPE Ethernet Link Guidelines

Follow these guidelines when configuring CPE Ethernet links:
•
•

Guidelines for Configuring Cisco 575 LRE CPEs and 576 LRE 997 CPEs

You can configure the CPE Ethernet port to operate at 10 or 100 Mbps and at half- or full-duplex mode,
depending on the capability of the remote Ethernet device. Autonegotiation for port speed and duplex
mode is supported.
The default speed for the CPE Ethernet port is auto. The default duplex mode is half duplex with back
pressure.
When the default speed is set to 10 or 100 Mbps with half duplex, the values set are the same.
shows the speed and duplex settings on the CPE Ethernet port and the switch Ethernet port.
The LRE link speed and duplex values are profile independent. All LRE links have a default speed of
Note
100 Mbps with half duplex except for the profile LRE-10 (on the Catalyst 2950ST-8 LRE and 2950ST-24
LRE switches), which is set to 10 Mbps with full duplex.
Table 13-5 Speed and Duplex Settings
CPE
Speed
10
10
100
100
The speeds on the LRE links and CPE Ethernet links do not need to match. However, to prevent the
possible loss of data when the LRE link is slower than the CPE Ethernet link, make sure that the CPE
Ethernet port is set to half-duplex mode. Use duplex autonegotiation only if the remote device supports
802.3x full-duplex flow control. The PC user should notice no significant difference in performance
78-11380-10
When the link between the LRE switch and the CPE device must co-exist in the same cable bundle
as an asymmetric digital subscriber line (ADSL), we recommend that you use either the ANSI
profile (LRE-998-15-4) or the ETSI profile (LRE-997-10-4). For details on which profile to use
elsewhere, consult the regulations for connecting to the PSTN in your area.
LRE signaling can co-exist with ADSL signaling in one cable bundle. However, LRE signaling is
not compatible with T1 signals in the same cable bundle.
Guidelines for Configuring Cisco 575 LRE CPEs and 576 LRE 997 CPEs, page 13-11
Guidelines for Configuring Cisco 585 LRE CPEs, page 13-12
Duplex
Full
Half
Full
Half
LRE Switch
Speed
10
10
100
100
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Configuring LRE Ports
Table 13-5
Duplex
Half
Half
Half
Half
13-11