Cisco 2950 - Catalyst Switch Configuration Manual page 444

Configuring MVR
Command
Step 6 mvr immediate
Step 7
end
Step 8
show mvr
show mvr interface
or
show mvr members
Step 9
copy running-config startup-config (Optional) Save your entries in the configuration file.
To return the interface to its default settings, use the no mvr [type | immediate | vlan vlan-id | group]
interface configuration commands.
This example shows how to configure a port as a receiver port, statically configure the port to receive
multicast traffic sent to the multicast group address, configure Immediate Leave on the interface, and
verify the results.
Switch(config)# mvr
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# mvr type receiver
Switch(config-if)# mvr vlan 22 group 228.1.23.4
Switch(config-if)# mvr immediate
Switch(config)# end
Switch# show mvr interface gigabitethernet0/1
Type: RECEIVER Status: ACTIVE Immediate Leave: ENABLED
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
21-20
Purpose
(Optional) Enable the Immediate Leave feature of MVR on the port.
Note This command applies to only receiver ports and should only be
enabled on receiver ports to which a single receiver device is
connected.
Return to privileged EXEC mode.
Verify the configuration.
Chapter 21 Configuring IGMP Snooping and MVR
78-11380-10