Discovery Through Non-Cdp-Capable And Noncluster-Capable Devices - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 7 Clustering Switches
Figure 7-2
Edge of
cluster

Discovery through Non-CDP-Capable and Noncluster-Capable Devices

If a command switch is connected to a non-CDP-capable third-party hub (such as a non-Cisco hub), it
can discover cluster-enabled devices connected to that third-party hub. However, if the command switch
is connected to a noncluster-capable Cisco device, it cannot discover a cluster-enabled device connected
beyond the noncluster-capable Cisco device.
Figure 7-3
However, the cluster command switch does not discover the switch that is connected to a Catalyst 5000
switch.
Refer to the release notes for the Catalyst switches that can be part of a switch cluster.
Figure 7-3
(non-CDP-capable)
Candidate switch
78-11380-10
Discovery through CDP Hops (Non-LRE Catalyst 2950 Command Switch Running Cisco
IOS Release 12.1(9)EA1 or Later)
Command switch
VLAN 16
Member
switch 8
Member
switch 9
Switch 11
candidate
switch
shows that the command switch discovers the switch that is connected to a third-party hub.
Discovery through Non-CDP-Capable and Noncluster-Capable Devices
Command switch
Third-party hub
VLAN 62
Member
switch 10
Switch 12
Candidate
Switch 13
switches
Switch 14
Switch 15
Catalyst 5000 switch
(noncluster-capable)
Candidate switch
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Planning a Switch Cluster
7-7