Configuring The Egress Queues; Configuring Cos Priority Queues - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 30 Configuring QoS

Configuring the Egress Queues

Note This feature is supported by both the SI and EI.
This section describes how to configure the egress queues:
•
•
•
For more information about the egress queues, see the

Configuring CoS Priority Queues

Beginning in privileged EXEC mode, follow these steps to configure the CoS priority queues:
Command
Step 1 configure terminal
Step 2
wrr-queue cos-map qid cos1...cosn
Step 3
end
Step 4
show wrr-queue cos-map
To disable the new CoS settings and return to default settings, use the no wrr-queue cos-map global
configuration command.
78-11380-10
Configuring CoS Priority Queues, page 30-37
Configuring WRR Priority, page 30-38
Enabling the Expedite Queue and Configuring WRR Priority, page 30-38
Purpose
Enter global configuration mode.
Specify the queue ID of the CoS priority queue. (Ranges are 1 to 4 where
1 is the lowest CoS priority queue.)
Specify the CoS values that are mapped to the queue id.
Default values are as follows:
CoS Value
0, 1
2, 3
4, 5
6, 7
Return to privileged EXEC mode.
Display the mapping of the CoS priority queues.
"Egress CoS Queues" section on page
CoS Priority Queues
1
2
3
4
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Configuring Standard QoS
30-9.
30-37